Darts / 【TRIPLEIGHT】T-arrowMAX Advent Taro Yachi Model
( 1 )

Main image of this product.

SPEC

Category Soft-tip Darts
Maker TRIPLEIGHT
Materials Tungsten 90%
Shape Torpedo
Cut Ring Cut , Shark Cut , Omega cut , Mulch Cut
Length 41.0mm
Weight (barrel Only) 18.5g
Standard 2BA
Maximum Diameter 6.9mm
Center Of Gravity Front
TRIPLEIGHT
T-arrowMAX Advent Taro Yachi Model
PRICE： JPY9,799
Expected：USD 64.53

Expected at JPY 151.83 for 1 USD.

This exchange rate is the closing price of yesterday ( 10/14 ).

The actual exchange rate will be determined when the order is paid.

Sold Out

trd2046

Product information

TRIPLEIGHT "T-arrow MAX descent "YACHI TARO

Taro Taniuchi's barrel series T-arrow has evolved into the T-arrow MAX!
The name is, "T-arrow MAX Descending"!

The barrel is 41.0mm in length, 6.9mm in maximum diameter, and has a perfect taper angle.
A sphere cut is placed between the main cut and the ohm cut, which is good for the grip and release.

The T-arrow MAX, with its harmonized specs, outline, cut and everything else, has come down again with an upgraded version.

Specifications
Material: 90% tungsten
Total length:41.0mm
Maximum diameter:6.9mm
Barrel Weight:18.5g
Standard:2BA

Contents
Barrel x 3 (1 set)
TRIPLEIGHT with logo x 3 (1 set)
LARO Shaft x 3 (1 set)
Premium Lippoint tip x 3 (1 set)

Japan Review

5.00

1 Reviews

 1
0
0
0
0
Sort By : Top reviews | Most recent | Highest Rating >> All Review View
Sort By :

2019-04-18

This is a redesign of an old dart that I'm not sure who remembers nowadays.
Personally, I thought the original T-Arrow MAX was one of the best in the series.
I feel that the name of the product is a bit of a misnomer.

First of all, the shape is more well thought out than I expected.
The impression is that it is finished in an orthodox way.
It is 6.9m, which is a little thin for a torpedo, but I have the impression that it fits well.
This is a thin setting for a torpedo, 6.9m, but I have the impression that it fits well with the shape.
However, the feel of the throw is not straight.
It is designed to be pushed by the shape of the rod.

Also, the cut is quite large in the photo, and the cut is a little thin.
The cut part may look a little thin, but it is not.
But when you hold it in your hand, you can feel that the cut part is straight from the barrel end including the cut part.
The cut itself is not too tight, and it is not too loose.
The cut itself is not too tight, not too loose, and not too noisy.
It is not too tight, not too loose, and not too noisy, and the balance of the push and pull is in a very good place.
The cut itself is not too tight, not too loose, and not too noisy, and it gives the impression that it has been properly designed.

The overall impression is of a very high standard and basic design.
I have the impression that it is as well-balanced and well-designed as the first generation.
However, if I were to speak of my personal preference, I would say that the front should be shaped a little more, and that it would be better if it were 1 to 2 mm shorter.
I have the impression that it would have been more appealing if the front had been shaped a little more, and if it had been shortened by 1 to 2 mm.

It is a good one.

13 people found this helpful